4.
Lift the USB board straight up (3) to remove it from the computer.
Reverse this procedure to install the USB board.
NOTE:
When reinstalling note that the screw goes into the upper hole.
Power connector cable
Description
Power connector cable (includes cable and connector)
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
Battery on page
45).
Hard drive on page
57)
Optical drive on page
Keyboard on page
62)
60)
Component replacement procedures
Spare part number
608273-001
77