HP Pavilion DM1z-3000 Maintenance And Service Manual page 43

6. Disconnect the hard drive/solid state drive connector from the system board (1), and then
remove the four screws (2) that secure the hard drive/solid state drive to the base enclosure.
7. Lift the hard drive/solid state drive out of the hard drive/solid state drive bay.
8. If it is necessary to replace the hard drive/solid state drive bracket or connector, follow these
steps:
a. Remove the 4 screws (1) that secure the hard drive/solid state drive bracket to the hard
drive/solid state drive.
ENWW Component replacement procedures 35