To Remove A Pc Card - HP OmniBook 800 User Manual

1. Turn over the OmniBook, release the two latches on the bottom of the
slot tray, and pull out the tray.
2. Lift or push the plastic spacer out of the tray. (Save the spacer in case
you remove the card later—it keeps dust and dirt from getting inside the
case.)
3. Install the new card into the tray with its face up and its connector holes
toward the metal tabs at the end of the tray.
4. Slide the tray fully into the slot and secure its latches.
Read-Write Switch. For a data storage card, you typically want to be able to
store or change data on the card. If the card has a read-write switch (on the
end of the card), make sure it is in its "read-write" position—usually away
from the nearest corner of the card. If you want to protect the data from
being changed, slide the write-protect switch to its "write-protect" or "read-
only" position before you insert the card.
A new data storage card (called a "disk") may already be formatted and
contain preloaded software—check its instructions. If you get errors when
you try to use a new disk, you may have to format it—see
storage card".
For an I/O card, you may need to install special software or adjust settings—
see "To set up an I/O

To remove a PC card

Caution
Do not remove a disk while it's actively reading or writing. If you
remove a disk while it's active, its data could become corrupted.
Do not remove an I/O card while an application is open that's set up to
use that card-exit the application first. If you remove the card, the
application (or the OmniBook) might behave unpredictably or stop
responding until you restart the OmniBook.
card".
"To format a data
35