Connecting an External Display
You can connect an external display device to your OmniBook. For
example, you can connect a VGA projection panel or a large VGA display.
1. Make sure the external display supports super VGA format.
2. Plug the VGA cable from the external display into the VGA output
connector at the back of the OmniBook.
VGA output
The OmniBook automatically recognizes and activates the external display.
The built-in display normally turns off to conserve power and backlight life. If
you keep it on, you may notice a slight dimming while the external display is
connected.
If you're using an external display with a higher resolution than your
OmniBook display, you must change the setting for display resolution and
disable the built-in display. See
Connecting an External Mouse
If you want, you can attach and use a 9-pin Microsoft serial or BallPoint
mouse or compatible mouse with your OmniBook in Windows.
To add an external mouse
Windows 95 automatically detects and enables an external mouse.
Unless you have a docking system, you will need to use a serial mouse
and connect it to the serial port. (This is the port marked IOIOI )
When you connect or disconnect an external serial mouse, click Start
and Shut Down, then restart Windows.
If you want to adjust the mouse behavior, see
settings".
To override the external mouse
VGA display
"To change the display settings."
"To change the mouse
38