Installation - Alpine X009-FD2 Quick Reference Manual

Installation

To install the X009, refer to the manual in the separately
purchased installation kit.
Caution
Do not block the unit's fan or heat sink, thus preventing
air circulation. If blocked, heat will accumulate inside
the unit and may cause a fire.
<example>
Air ventilation hole
Rear of the Unit
Caution concerning the installation location
1
Before installing, make sure that the opening and
closing of the display will not interfere with
operation of the gear shift.
Movable Display
2
Angle of installation
Install at an angle between horizontal and 30°. Note
that installing at an angle outside of this range will
result in a loss of performance and possibly
damage.
0 - 30°
3
Mounting the GPS Antenna inside the vehicle.
1 Clean the mounting location.
2 Put on the GPS Antenna mounting plate.
3 Mount the GPS Antenna.
• Mount the GPS Antenna on a flat plane of the dash board or
Heat sink
• Some thermal reflection type or thermal absorption type glass
• Make sure the GPS Antenna is not covered (obstructed) by any
Antenna mounting plate
rear tray.
may interrupt high frequency waves. If reception is poor with
the antenna installed inside the car, try to mount the antenna
outside the car.
metallic surface or object.
GPS Antenna
109
-EN