Alpine X009-FD2 Quick Reference Manual page 14

Installation
To install the X009, refer to the manual in the
separately purchased installation kit.
• When making connections to the vehicle's electrical
system, be aware of the factory installed components
(e.g. on-board computer). Do not tap into these leads to
provide power for this unit. When connecting the X009
to the fuse box, make sure the fuse for the intended
circuit of the X009 has the appropriate amperage. Failure
to do so may result in damage to the unit and/or the
vehicle. When in doubt, consult your Alpine dealer.
• The Display must be completely retracted in the casing
when installing.
If
it is not, problems may occur.
1
Before installing, make sure that the
opening and closing of the display will not
interfere with operation of the gear shift.
Movable Display
2
Install at an angle between horizontal
and 30°. Note that installing at an angle
outside of this range will result in a loss of
performance and possibly damage.
,'
..
,.,
....
, I ' ....
,' 1,' ........
, f ........
, I
....
'
I
I
I
3
Installation
Mounting the GPS Antenna inside the
vehicle.
1 Clean the mounting location.
2 Put on the GPS Antenna mounting plate.
3 Mount the GPS Antenna.
GPSAntenna
Antenna mounting plate
• Mount the GPS Antenna on a flat plane of the
dash board or rear tray.
• Some thermal reflection type or thermal
absorption type glass may interrupt high
frequency waves. If reception is poor with the
antenna installed inside the car, try to mount the
antenna outside the car.
• Make sure the GPS Antenna is not covered
(obstructed) by any metallic surface or object.
13-EN