To Remove A Pc Card - HP OmniBook 5700 Installation And Setup Manual

C A U T I O N
Starting Out with Your OmniBook
Using OmniBook Accessories
About RAM Cards
If you're using a RAM card with the OmniBook, keep these suggestions in mind:
For a new RAM card, install its battery before you insert the card.
Replace the RAM card battery yearly.
When you want to replace a RAM card battery, plug the card into the OmniBook and make sure the
OmniBook stays turned on while you replace the battery. You can plug in the ac adapter to keep it
from turning off. Otherwise, the data on the card will be lost.

To remove a PC card

Never remove an I/O card while an application is open that's set up to use that
card. Exit the application first. If you remove the card, the application (or the
OmniBook) might behave unpredictably or stop responding until you restart
the OmniBook. Never insert or remove a plug -in card while the PC card drive is
actively reading or writing data. Wait until the PC card drive is done.
Otherwise, you could lose data or the OmniBook could stop responding.
1. If you're using Windows 95
Click the PC card indicator in the taskbar, then click Stop. This protects your
data and avoids unexpected problems. You can restart the card by removing it,
then inserting again
If you're using Windows for Workgroups
Go to step 2.
2. If necessary, rotate the ejector button so that it protrudes from the case.
3. Press the black ejector button until the card pops out, then pull out the card.
1-30