Replacing Hardware; To Remove The Hard Disk Drive - HP OmniBook 5700 Installation And Setup Manual

Replacing Hardware

This section describes how to
Remove and install the hard disk drive.
Find the system software version and memory size.
Install a memory-expansion board.

To remove the hard disk drive

You can upgrade the OmniBook system by installing a new hard drive or you may
want to switch hard drives between OmniBooks.
1. Important
Back up all the files on your current drive C. You can back up the files to a tape
drive, a network drive, a PC card, or a flexible disk.
2. Unplug the adapter.
3. Exit Windows.
If you're using Windows 95, use the shutdown option from the Start menu.
If you're using Windows for Workgroups, exit Windows, then press
the Off button.
4. Remove all batteries from the OmniBook.
5. Close the cover and turn your computer over.
6. Remove the screw and security cover located at the back of the hard disk drive.
7. Firmly slide the drive out of the drive compartment. (This requires some force.)
Refer to the next topic to install a hard disk drive.
Expanding the OmniBook
Replacing Hardware
3-3