Table of Contents
Advertisement
TouchPad button board
Description
Touchpad button board (includes bracket and cable)
Before removing the TouchPad button board:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn on
the computer, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first disconnecting the power cord from the AC
outlet and then disconnecting the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
d.
Top cover (see
Remove the TouchPad button board:
1.
Turn the top cover upside down with the front toward you.
2.
Remove the four Phillips PM2.0×3.0 screws (1) that secure the TouchPad bracket to the top
cover.
3.
Lift up and remove the TouchPad button board bracket (2). The TouchPad button is fused on the
TouchPad button board bracket.
Reverse the above procedure to reassemble and install the TouchPad button board.
62
Chapter 4 Removal and replacement procedures
Battery on page
42).
Hard drive on page
43)
Optical drive on page
Keyboard on page
54)
Top cover on page
57)
46)
Spare part number
616493-001
ENWW
Advertisement
Table of Contents
