Table of Contents
Advertisement
4.
Release the power connector (4) from the alignment clip built into the base enclosure.
5.
Remove the power connector cable.
Reverse this procedure to install the power connector cable.
System board
NOTE:
The system board spare part kit includes replacement thermal material.
Description
For use only on computer models equipped with an Intel Core i7 processor
For use only on computer models equipped with an Intel Core i5, i3, or P6000 processor
Before removing the system board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery cover and battery (see
5.
Remove the hard drive (see
6.
Remove the memory module/wireless module compartment cover (see
on page
7.
Disconnect the battery charger board ribbon cable from the system board (see
board on page
62
Chapter 4 Removal and replacement procedures
Mass storage device on page
41).
48).
Battery on page
34).
36).
Spare part number
608365-001
608364-001
WLAN module
Battery connector
Advertisement
Table of Contents
