Standard-Voltage Hard Drive Or Solid-State Drive - HP EliteBook 2540P Maintenance And Service Manual

Standard-voltage hard drive or solid-state drive

NOTE: Installation of the 6.35-cm (2.50-in) hard drive or solid-state drive in the hard drive bay is not
supported. The 6.35-cm (2.50-in) hard drive or solid-state drive cannot be installed when the optical
drive is installed.
Description
2.50-in, 500-GB, 7200-rpm hard drive
2.50-in, 320-GB, 7200-rpm hard drive
2.50-in, 320-GB, 7200-rpm SED hard drive
2.50-in, 250-GB, 7200-rpm hard drive
Hard drive carrier
1.80-in 160-GB, solid-state drive
1.80-in 80-GB, solid-state drive
NOTE: The standard-voltage hard drive or solid-state drive must be installed in the optical drive
bay, and replaces the optical drive.
Before removing the standard-voltage hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery. (See
5. Remove the memory module compartment cover (see
ENWW
Battery on page 48)
Expansion memory module on page
Component replacement procedures
Spare part number
598781-001
598780-001
618243-001
598779-001
598786-001
598783-001
602676-001
52).
65