4.
Remove the battery (see
5.
Remove the following components:
a.
Memory module compartment cover (see
b.
Wireless module compartment cover (see
c.
Switch cover and keyboard (see
d.
Display assembly (see
e.
Top cover (see
f.
System board (see
Remove the fan/heat sink assembly:
1.
Turn the system board upside down, with the front toward you.
2.
Disconnect the fan cable (1) from the system board.
3.
Remove the Torx T8M2.0×5.0 screw (2) that secures the fan/heat sink assembly to the system
board.
4.
Following the 1, 2, 3, 4 sequence stamped into the fan/heat sink assembly, loosen the four
captive screws (3) that secure the fan/heat sink assembly to the system board.
5.
Remove the fan/heat sink assembly (4).
ENWW
Battery on page
48), and then remove the following components:
Switch cover and keyboard on page
Display assembly on page
Top cover on page
85)
System board on page
Expansion memory module on page
WLAN module on page
76)
94)
Component replacement procedures
52)
57)
69)
99