Usb/Power Connector Board; Fan/Heat Sink Assembly - HP Compaq Presario,Presario V6500 Maintenance And Service Manual

Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Optical drive (see
b.
Switch cover (see
c.
Keyboard (see
d.
Display assembly (see
e.
Top cover (see
f.
Audio board (see
g.
USB/power connector board (see
h.
System board (see
i.
Remove the fan/heat sink assembly:
Turn the system board upside down, with the expansion port 3 and external monitor port toward
1.
you.
Disconnect the fan cable (1) from the system board.
2.
Loosen the three Phillips PM2.5×5.0 captive screws (2) and the Phillips PM2.5×4.0 captive
3.
screw (3) that secure the fan/heat sink assembly to the system board.
Remove the fan/heat sink assembly (4).
4.
NOTE: Due to the adhesive quality of the thermal material located between the fan/heat sink
assembly and system board components, it may be necessary to move the fan/heat sink assembly
from side to side to detach the assembly.
Battery on page 42).
Hard drive on page 43)
Optical drive on page
Switch cover on page
Keyboard on page 55)
Display assembly on page
Top cover on page 65)
Audio board on page
USB/power connector board on page
System board on page
51)
53)
59)
75)
72)
Component replacement procedures
71)
77