HP Compaq Presario,Presario R4000 Hardware And Software Manual page 132

Modem and Networking
■
Check the telephone number you are dialing and the
response of the remote modem.
Dial the telephone number on the telephone, make sure there
is a response from the remote modem, and then hang up.
■
Set the modem to ignore dial tones.
If the modem receives a dial tone it does not recognize, it will
not dial and will display a No Dial Tone error message.
To set the modem to ignore all dial tones before dialing:
1. Select Start > Control Panel > Printers and Other
2. Select the Modems tab.
3. Select your modem.
4. Select Properties.
5. Select the Modem tab.
6. Clear the check box for Wait for Dial Tone Before
7. Select OK > OK.
If you continue to receive the No Dial Tone error message
after clearing the Wait for Dial Tone Before Dialing
check box:
1. Select Start > Control Panel > Printers and Other
2. Select the Dialing Rules tab.
3. Select your current modem location setting.
4. Select Edit.
5. Select your current location from the Country/region
6. Select Apply, and then select OK.
10–8
Hardware > Phone and Modem Options.
Dialing.
Hardware > Phone and Modem Options.
drop-down list. (If you select a country or region that is
not supported by the modem, the Country/region
selection for USA or UK is displayed by default.)
Hardware and Software Guide