The Web User Interface - Aztech WR300 User Manual

The Web User Interface

The Web User Interface of your WL580E allows you to configure the various
features of your WL580E. This will serve as your main tool in monitoring and
configuring all of your WL580E's main features.
Accessing the Web User Interface
NOTE: To avoid any conflicts in accessing the Web User Interface, it is strongly
advised to do the following:
• Simply access the Web User interface through an Ethernet connection.
This is achieved by connecting your Computer and your WL580E
through an Ethernet cable.
• If present, kindly turn off the wireless adapter of your computer. You
may enable the wireless adapter after completing the setup. This is to
avoid IP address conflict which might block you from accessing the
Web user interface.
• Remove temporary Internet files.
To access the Web User Interface through an Ethernet connection:
1. Connect your computer to the WL580E device using an Ethernet cable.
NOTE: before proceeding to step 2, please check the SMART LED of the
device; the LED should be in GREEN WEAK status and BLINKING.
2. Launch any web browser. You would automatically be redirected to
your WL580E's web user interface.
3. If in any case it does not, kindly type 10.0.10.254 on the address bar
and press Enter. You will then be redirected to the Home page of your
WL580E's web user interface.
4. Upon redirecting, a window showing the wireless networks within range
would appear. You may close this mini window or choose to connect
to your preferred wireless network immediately.
User Manual
Page 9 of 35