HP Compaq Presario,Presario 2105 Reference Manual page 118

Conexant AT Commands (Advanced Users Only) (Continued)
Command
+MR=0
+MR=1
+MR=2
+MS
= a,b,c,
d,e,f
+WS=
n
ECC Commands
Command
%C
n
+EB=
a,b,c
+EFCS=0
Reference Guide
(Conexant)
Disable reporting of modulation connection.
Enable reporting of modulation connection (
are transmitted) (default).
Enable reporting of modulation connection (
Rate Only: are transmitted).
Select modulation ( b, c, d, e, and f are optional).
■
a is the carrier (allowable rates in parentheses):
B103 (300), B212 (1200 Rx/75 Tx or 75 Rx/1200 Tx), V21
(300), V22 (1200), V22B (1200/2400), V23C (1200),
V32(4800/9600), V32B (4800-14400), V34 (2400-33600),
K56 (32000-56000), V90 (28000-56000),
V92 (downstream: 28000–56000;
upstream: 24000–48000).
■
b is automode: 0=disabled, 1=enabled (default).
■
c is minimum transmit (Tx) rate (bps).
■
d is maximum transmit rate (bps).
■
e is minimum receive (Rx) rate.
■
f is maximum receive rate (bps).
Set PDC mode: 1=disable (default), 20=enable.
(Conexant)
Set data compression: 0=disable, 1=enable V.42 bis and
MNP 5, 2=enable V.42 bis and MNP 5, 3=enable V.42 bis
and MNP 5 (default).
Select break handling ( b and c are optional):
■
a =0 break is ignored.
■
b =0 transmitted V.42 L-SIGNAL will not indicate break
signal length.
■
c =0 break is not delivered to DTE.
Select 16-bit FCS specified in V.42.
Reference Information
+MCR: +MRR:
and
+MCR:
and Receive
7–9