D&H PD05A Manual page 48

Locomotive/Locomotive function decoder
48 48
CV
153 Initial mapping
Bit Function
0........LV ...............................1
1........LR ..............................2
2........AUX1 .........................4
3........AUX2 .........................8
These function outputs are active as soon as the decoder is addressed
(without active function key). Thus, for example, the switchover of the sliding contacts
can be realized in connection with the conditions.
154 Brake ramp forward and backward
Recommended for constant braking distance: CV48 = 0
0 = deactivated
If maximum speed step braking time is adjusted in seconds times 8, at smaller speed
steps the decoder generates the brake ramp independently
155 Brake ramp backward
0 = value from CV154 is used
Alows different brake times forward and backward
156 Dimming mask for low beam light
Bit Function
0........LV ...............................1
1........LR ..............................2
2........AUX1 .........................4
3........AUX2 .........................8
157 Conditions for low beam light
BA DH engl FW3_12 Druck.indd 48 BA DH engl FW3_12 Druck.indd 48
Fahrzeug-/Funktionsdecoder
Name and definition
Value Bit Function
4 ...... AUX3 ...................................... 16
5 ...... AUX4 ...................................... 32
6 ...... AUX5 ...................................... 64
7 ...... AUX6 ..................................... 128
(see CV27, not relevant to PD05A/PD06A)
Value Bit Function
4 ...... Currently without function ...... 16
5 ...... Currently without function ...... 32
6 ...... Currently without function ...... 64
7 ...... Currently without function .... 128
from firmware version 3.12 ab Firmware-Version 1.11
Range
0-255
(not relevant to PD*)
Value
0-255
0-255
(see CV154)
(see CV53)
Value
0-161
(see CV145)
Standard
0
0
0
0-15 3
0
10.05.21 14:27 10.05.21 14:27