Advertisement
Quick Links
Advertisement
Related Manuals for Zanussi ZGG96524XX
Summary of Contents for Zanussi ZGG96524XX
- Page 1 User Manual GETTING STARTED? EASY. ZGG96524XX EN User Manual...
- Page 2 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
- Page 3 CAUTION: The appliance must not be supplied through an • external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by a utility. CAUTION: The cooking process has to be supervised. A short •...
- Page 4 • Keep the minimum distance from other • Make sure not to cause damage to the mains appliances and units. plug (if applicable) or to the mains cable. • Always take care when moving the appliance as Contact our Authorised Service Centre or an it is heavy.
- Page 5 • Make sure the flame does not go out when you quickly turn the knob from the maximum to the WARNING! Risk of injury, burns and minimum position. electric shock. • Use only the accessories supplied with the appliance. • Remove all the packaging, labelling and •...
- Page 6 • Disconnect the appliance from the mains • Flat the external gas pipes. supply. • Cut off the mains electrical cable close to the appliance and dispose of it. INSTALLATION Location WARNING! Refer to Safety chapters. The hob may be located in a kitchen, a kitchen/ diner or bed sitting room (with a volume greater than 20 m³), but not in a bathroom or shower room.
- Page 7 5. Attach the label with the new type of gas supply near the gas supply pipe. You can find this label in the package supplied with the appliance. If the supply gas pressure is changeable or different from the necessary pressure, you must fit an applicable pressure adjuster on the gas supply pipe.
- Page 8 • or E — Earth terminal Before carrying out the connection, make sure: 1. The limiter valve and the electrical system can take the appliance load (see the rating plate) 2. The supply system is equipped with an efficient earth connection in compliance with the current standards and regulations 3.
- Page 9 REPLACEMENT OF THE CONNECTION ASSEMBLY CABLE The replacement of electric cable must be carried out exclusively by the service force centre or by personnel with similar competencies, in accordance with the current regulations. To replace the connection cable use only H03V2V2-F T90 or equivalent type.
- Page 10 If a furniture unit is installed at a distance of 400 mm above the hob, there must be a minimum safety distance of 50 mm to the left or right from the edge of the hob. CAUTION! Install the appliance only on a worktop with flat surface.
- Page 11 PRODUCT DESCRIPTION COOKING SURFACE LAYOUT Semi-rapid burner Multi Crown burner Auxiliary burner Rapid burner Control knobs CONTROL KNOB Symbol Description Symbol Description minimum gas supply no gas supply / off position ignition position / maximum gas supply DAILY USE WARNING! Refer to Safety chapters. BURNER OVERVIEW A.
- Page 12 IGNITION OF THE BURNER If the burner accidentally goes out, Always light the burner before you put turn the control knob to the off position on the cookware. and try to light the burner again after minimum 1 minute. WARNING! Be very careful when you The spark generator can start use open fire in the kitchen automatically when you switch on the...
- Page 13 CAUTION! Make sure that pot Diameter of cook- handles are not above the front edge Burner ware (mm) of the cooktop. CAUTION! Make sure that the pots Multi Crown 180 - 260 are placed centrally on the burner in order to get the maximum stability and Rapid 180 - 260 a lower gas consumption.
- Page 14 PERIODIC MAINTENANCE Speak to your local Authorised Service Centre periodically to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. TROUBLESHOOTING WARNING! Refer to Safety chapters. WHAT TO DO IF... Problem Possible cause Remedy There is no spark when you try The hob is not connected to an Check if the hob is correctly to activate the spark generator.
- Page 15 LABELS SUPPLIED WITH THE ACCESSORIES Stick the adhesive labels as indicated below: MOD. MOD. MOD. TYPE PROD.NO. IP20 PROD.NO. PROD.NO. SER.NO. 0049 SER.NO SER.NO 03 IT DATA DATA MADE IN ITALY A. Stick it on Guarantee Card and send this part C.
- Page 16 OTHER TECHNICAL DATA Gas original: G20 (2H) 20 mbar 11,65 kW TOTAL POW- Gas replace- G30 (3+) 28-30 mbar 832 g/h ment: G31 (3+) 37 mbar 818 g/h Electric supply: 220-240 V ~ 50-60 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Appliance cate- II2H3+ gory:...
- Page 17 Data in the table is specified for Malta. ENERGY EFFICIENCY PRODUCT INFORMATION ACCORDING TO EU 66/2014 Model identification ZGG96524XX Type of hob Built-in hob Number of gas burners Left front - Semi-rapid 55.3% Left rear - Semi-rapid 57.4% Energy efficiency per gas burner Middle - Multi Crown 54.3%...
- Page 20 WWW.ZANUSSI.COM/SHOP...