NordicTrack NETL15818.1 User Manual page 32

SYMPTOM: The walking belt slips when walked on
a. First, remove the key and UNPLUG THE POWER
CORD. Using the hex key, turn both idler roller
screws clockwise, 1/4 of a turn. When the walk-
ing belt is correctly tightened, you should be able
to lift each edge of the walking belt 2 to 3 in. (5 to
7 cm) off the walking platform. Be careful to keep
the walking belt centered. Then, plug in the power
cord, insert the key, and walk on the treadmill for a
few minutes. Repeat until the walking belt is prop-
erly tightened.
a
SYMPTOM: The tablet holder does not stay in place
a. Rotate the tablet holder (C) backwards. Then,
tighten the indicated screw (D) slightly until the
tablet holder stays in place when it is rotated to the
desired position.
a
C
D
SYMPTOM: The treadmill will not connect to the
wireless network
a. Make sure that the wireless settings on the console
are correct (see page 27).
b. Make sure that the settings for your wireless net-
work are correct.
c. If you still have questions, go to support.iFit.com.
SYMPTOM: The displays of the console do not
function properly
a. If the console does not boot up properly, or
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
power off the treadmill. Next, locate the small reset
opening (E) near the USB port on the console.
Using a bent paper clip (F), press and hold the
reset button inside the opening, and have a second
person power on the treadmill. Continue holding
the reset button until the console turns on. When
the reset operation is complete, the console will
turn off and then turn back on. If it does not, power
the treadmill off and then on again. Once the
console turns on, check for fi rmware updates (see
HOW TO USE THE MAINTENANCE SECTION on
page 26). Note: It may take a few minutes for the
console to be ready for use.
a
32
E
F