HP Compaq NC6220 Hardware And Software Manual page 137

■
Check the telephone number you are dialing and the
response of the remote modem.
Dial the telephone number on the telephone, make sure there
is a response from the remote modem, and then hang up.
■
Set the modem to ignore dial tones.
If the modem receives a dial tone it does not recognize, it will
not dial and will display a "No Dial Tone" error message.
To set the modem to ignore all dial tones before dialing:
1. Select Start > Control Panel > Network and Internet
2. On the upper menu in the left panel of the Network and
3. Select Modems.
4. Select your modem.
5. Select Properties.
6. Select Modem.
7. Clear the check box for Wait for Dial Tone Before
8. Select OK > OK.
If you continue to receive the "No Dial Tone" error message
after clearing the Wait for Dial Tone Before Dialing check
box:
1. Select Start > Control Panel > Network and Internet
2. On the upper menu in the left panel of the Network and
3. Select Dialing Rules.
4. Select your current modem location setting.
5. Select Edit.
Hardware and Software Guide
Connections.
Internet Connections window, select Phone and
Modem Options.
Dialing.
Connections.
Internet Connections window, select Phone and
Modem Options.
Modem and Networking
10–7