Intermec SR61XR User Manual page 54

Chapter 5 — Troubleshooting and Maintaining the SR61T
42
e Click the link to download the firmware upgrade package and
save it to your PC.
f Unzip the .zip file.
2 Connect your SR61T to a host PC with the appropriate cable
Note: If using a USB cable, you must use the USB Virtual Com
USB cable mode. See
3 Scan the Reset Factory Defaults bar code:
Reset factory defaults
4 Start EasySet version 5.6.4.0 or later.
5 From the Tools menu, select Upgrade product firmware to start
WinFlash version 3.1.1.1 or later.
6 If WinFlash is not already installed you will be asked to install it.
Click Yes and following the installation instructions. After
installing Winflash, start WinFlash from the Tools menu, select
Upgrade product firmware.
"USB Cable Mode" on page
SR61T Tethered Scanner User's Guide
25.