Intermec SR61XR User Manual page 52

Chapter 5 — Troubleshooting and Maintaining the SR61T
40
Problems and Possible Solutions (continued)
Problem
You scan a bar code and
the status light turns
on, but the SR61T does
not beep.
You scan a
configuration bar code
and the SR61T beeps six
very fast beeps.
You scan a bar code, the
SR61T beeps once, and
the status light blinks
green once, but the data
is not transmitted to the
host computer.
You cannot scan the
Firmware upgrade bar
code on your computer
screen.
Possible Solution
The beep duration, volume, frequency, and
number may be configured so the SR61T does not
beep. To reset the SR61T, scan this bar code:
Reset factory defaults
The SR61T does not recognize or support the
configuration bar code you scanned.
Try these possible solutions:
•
Make sure that your data collection application
is set up to receive data from the SR61T.
•
If you are using an RS-232 cable, make sure that
the serial parameters on the SR61T match the
serial parameters of the host computer. The
default serial parameters for the SR61T are:
57600 baud, 8 data bits, no parity, and 1 stop
bit.
Print out this bar code and scan it:
Firmware upgrade
SR61T Tethered Scanner User's Guide