Wi-Fi Protected Setup (Wps); Using Wps To Connect To A Network - Epson ET-2803 User Manual

Note: If the
these steps to try again.
Parent topic:
Related references
Status Icon Information

Wi-Fi Protected Setup (WPS)

If your network uses a WPS-enabled wireless router or access point, you can quickly connect your
product to the network using Wi-Fi Protected Setup (WPS).
Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access
point. If there is no hardware button, there may be a virtual WPS button in the software for the device.
Check your network product documentation for details.

Using WPS to Connect to a Network

Parent topic:
Using WPS to Connect to a Network
If you have a WPS-enabled router or access point, you can use Wi-Fi Protected Setup (WPS) to connect
your product to the network.
1. Press the WPS button on your router.
2. On the product, press the
3. Press the arrow buttons to select Wi-Fi Setup then press the OK button.
icon is displayed on the LCD screen, Wi-Fi Direct mode is not enabled. Repeat
Wi-Fi Direct Mode Setup
Wi-Fi Networking
home button, if necessary.
38