Table of Contents
Advertisement
3.2 Definition of Cable
The description of 10 cables is shown below.
Color
Orange
White
Green
Green
Yellow
Red
Black
Gray
Purple
Brown
3.3 Wiring Cables
Purpose:
Wire the cables between controller and card reader, thus to
establish the communication between them.
Steps for RS-485 communication mode:
1.
Set the DIP switch of No. 6 as 0.
2.
Set the DIP switch of No. 1 ~ 4 for RS-485 address and
reading card mode. For details, please refer to 3.1
Introduction for DIP Switch.
3.
Wire the cable between controller and card reader as
Table 3-3 Description of Cable
Red LED Control (available for Wiegand Protocol)
Wiegand W1 (available for Wiegand Protocol)
Wiegand W0 (available for Wiegand Protocol)
RS-485-
RS-485+
PWR (+12 VDC)
GND
TAMPER (available for Wiegand Protocol)
Beep Control (available for Wiegand Protocol)
Green LED Control (available for Wiegand
Protocol)
Description
6
Advertisement
Table of Contents
