5
7. DISASSEMBLY
Note 1: Do NOT look directly into the pickup lens. The laser beam may cause eye injury.
Note 2: Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures
described here are common.
Diagnosis of PCB's
1
Bonnet, Tray Panel
1
Remove the bonnet by removing the nine screws.
2
Press the STANDBY/ON button to turn on the
power.
3
Press the OPEN/CLOSE button to open the tray.
4
Remove the tray panel.
5
Set the test disc.
6
Press the OPEN/CLOSE button to close the tray.
(Test disc is clamped.)
7
Press the STANDBY/ON button to turn off the
power.
8
Pull out the Power cord.
How to open the tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the
bottom of the unit, and slide the projection of the drive
cam in the 06 LOADER Assy in the direction of the
arrow, as indicated in the photo. If the tray pops out a
little, fully pull it out by hand.
Projection
Drive cam
06 LOADER Assy
5
6
Screwdriver (small)
Bottom view
6
7
2
7
5
Test disc
4
3
Tray
6
Tray panel
Tray open
XV-DV363
7
8
3
6
Slit
Screwdriver (small)
8
A
B
C
D
E
F
33