Pioneer XV-DV363K Service Manual page 43

5
8.1.5 MECHANISM ADJUSTMENT
Tangential and Radial Height Coarse Adjustment
1
START
Remove the 06SD Pickup Assy-S from the Traverse Mechanism Assy-S.
Remove the joint and the joint spring of the 06SD Pickup Assy-S.
Note:
Before removing the flexible cable for the pickup,
soldering of the pickup circuit is necessary.
For details, see "7. DISASSEMBLY".
Pass through the guide shaft to a new 06SD Pickup Assy-S.
Attach it to the Traverse Mechanism Assy-S.
Put the joint between the Tangential (or Radial) adjustment scrw and the mechanism base
and turn each screw to adjust the height.
(Refer to "8.1.1 ADJUSTMENT ITEMS AND LOCATION".)
Attach the Traverse Mechanism Assy-S to the 06 LOADER Assy.
Turn it over and attach the joint and the joint spring.
Arrange the flexible cables.
(Refer to "7. DISASSEMBLY".)
5
6
Guide Shaft
XV-DV363
6
7
06SD Pickup Assy-S
Joint VK1B
Joint spring VK1
Hold spring
06SD Pickup Assy-S
Joint
7.5mm
Mechanism base
7
8
A
B
C
D
E
F
43
8