Troubleshooting - Textron GREENLINE GATOR EK6IDL Operation Manual

Troubleshooting

Before You Begin
1. Make sure that the battery is charged. Recheck
the battery after several minutes to make sure the
battery is holding its charge.
Problem
Tool is inoperative.
Motor is inoperative.
Motor runs but tool will not
complete a cycle.
LED glows for 20 seconds.
Tool loses oil.
Note: For warranty claims, send tool to Greenlee CTSC Service Center.
Greenlee / A Textron Company
EK6IDL Battery-powered Dieless Crimping Tool
Possible Cause
Dirt, contaminants, etc.,
in ram area of tool.
Tool components worn or
damaged.
Low or uncharged battery.
Broken switch components.
Oil level low.
Air in hydraulic system.
Cold oil.
Battery charge low.
Damaged internal seal.
2. Use a nonflammable contact cleaner or pencil
eraser to clean the electrical contacts on the battery
and tool.
3. Reinstall the battery and check the tool again.
Probable Remedy
Clean tool.
Return tool to a Greenlee Authorized Service
Center.
Try known charged battery. Inoperative battery
may be discharged or may have reached life
expectancy.
Return tool to a Greenlee Authorized Service
Center.
Return tool to a Greenlee Authorized Service
Center.
Pull trigger and hold retract button simultane-
ously. Run for approximately 10 seconds, and
then attempt to crimp. If unsuccessful, return
tool to a Greenlee Authorized Service Center.
Pull trigger and hold retract button simultane-
ously to warm oil. Store tool in warm area.
Charge or replace battery.
Return tool to a Greenlee Authorized Service
Center.
11
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070