Omega OBO650X1 Instruction Manual page 9

Installation
Insert the oven into cabinet partly by pushing it forward. Open the oven door and insert 2 screws into the holes on the
oven frame. While the product frame touches the wooden surface of the cabinet, tighten the screws.
If the oven is installed below a built-in hob, the distance between the worktop and the top panel of the oven must be a
minimum of 50mm, and the distance between the worktop and the top of the oven control panel must be a minimum of
25mm. The front of the oven will remain in front of the cabinet.
The dimensions and material of the cabinet in which the oven will be installed must be correct and resistant to
increases in temperature. In a correct installation, contact with electrical or insulated parts must be prevented.
Insulating parts need to be fitted in a way to ensure that they cannot be removed by using any kind of tool.
Installing the appliance in the close vicinity of a refrigerator or a deep-freezer is not recommended as the performance
of the above-mentioned appliances will be negatively affected due to emanating heat. After removing your oven from
its packaging, be sure that the oven is not damaged. If you suspect any damage to the appliance, do not use it;
immediately contact an authorised Service Centre.
INSTALLATION IN AN ELEVATED CABINET
INSTALLATION UNDER COUNTER
9