Adjusting Your Monitor Image; Using The User Controls; Using The Osd Controls - Lenovo ThinkCentre TIO22Gen4Touch User Manual

Adjusting your monitor image

This section describes the user control features used to adjust your monitor image.

Using the user controls

Your monitor has four user controls on the front panel. To locate the user controls, see
connectors and controls on your monitor"on page 1-5. You can use the user controls to adjust some
settings of your monitor on the On Screen Display (OSD) main menu.
•
•
•
•

Using the OSD controls

To use the controls:
1.
2.
3. Press
4. Press and hold
5.
Back button
Used to move back and exit from the OSD menu.
UP button / Mode-switching button
Used to move to the left on the OSD menu and switch between the AIO mode (using the Tiny
installed) and the DP mode (using an external desktop/laptop computer).
Down button / brightness control
Used to move to the right on the OSD menu and adjust the brightness.
Selection button / menu-opening button
Used to open the OSD main menu and select an option.
The settings adjustable with the user controls are viewed through the OSD, as shown below.
Note: When switching to AIO mode, the monitor and the Tiny share the same power button on the
monitor, However, if the enhanced power saving mode is enabled in the BIOS of the Tiny, you can
only use the power button of the computer to turn on the computer.
TIO22Gen4Touch
®
Monitor Controls Brightness
Advanced Settings Contrast
Volume
Port Settings
Menu Settings
Exit
Input Signal: DisplayPort Resolution: 1920x1080
Press to open the main OSD menu.
Use or to move among the icons. Select an icon and press
function. If there is a sub-menu, you can move between options using
press to select that function. Use
to move backwards through the sub-menus and exit from the OSD.
for 10 seconds to lock the OSD. This will prevent accidental
adjustments to the OSD. Press and hold
adjustments to the OSD.
DDC/CI is enabled by default.Press and hold
function.The words"DDC/CI Disable"/"DDC/CI Enable" shows on the screen.
75
75
50
Refresh Rate: 60Hz
or to make adjustments
for 10 seconds to unlock the OSD and allow
for 5 seconds to disable/enable DDC/CI
"Locating
to access that
or , then
ress to save.
2-8
Chapter 2.