Advertisement
19
Place blade bracket onto the
front side of blade by aligning
t h e 3 h o l e s o n b l a d e a s
shown.
22
L o o s e n 2 a n d r e m o v e 1
preassembled screws from the
plate on motor. Save screw for
later use.
25
Attach capacitor onto switch
housing by preadhered double-
sided foam tap as shown.
© 2013 Monte Carlo Fan Company
20
Install blade bracket with blade by
3 blade screws provided. Tighten
securely. Repeat this process for
remaining blades.
Note: Make sure the side with a label
"This side up" is installed upward.
23
Place switch housing over wire harness
from motor. Attached switch housing
on to the plate on motor, aligning the
keyhole slots with the preassembled
screws on the plate. Twist clockwise till
lock. Install the screw removed in step
22. Tighten all screws securely.
26
Remove 3 preassembled screws
from switch housing cover. Save
screws for later use.
5
21
Check motor for shipping stabilizers
and remove if present. Install the blade
assembly to motor using the screws
pre-installed. Tighten screws securely.
Repeat this process for remaining blade
assemblies.
24
Hook
Connect plug from fan to plug
from switch housing. Make sure
the plugs are hooked together.
27
Attach switch housing cover onto
switch housing by aligning the long
slot on switch housing cover with
the reverse switch preassembled on
switch housing as shown.
Shipping
stabilizer
7/1/2013
Advertisement
