Whirlpool AMAP101AB Use And Care Manual page 6

Assemble Vent Hose
1.
Attach vent hose to air conditioner
Insert the round connector of the vent hose into the exhaust
port on the back of the air conditioner. Turn counterclockwise to
lock into place.
2.
Attach vent hose to slider panel
Slider panel
Position the air conditioner in the desired location.
Extend the vent hose enough to reach from the air conditoner
to the window. Be sure there are no sharp bends or kinks in the
hose.
Press the window connector end of the vent hose into the
opening on the slider panel as shown. It will clip into place.
6
Drain Hose Connection (optional)
When using the air conditioner for dehumidification only, you may
attach a hose (not included) for water drainage into a floor drain.
The drain hose must be below the drain port on the back of the
air conditioner.
1.
Remove drain fitting plug
Turn the drain port retainer plug counterclockwise to remove,
then pull out the rubber drain plug.
2.
Install drain hose
Window
connector
Insert the drain hose into the drain fitting on the air conditioner.
Insert the other end of the drain hose into a floor drain or other
suitable drain.