Fan Assembly - HP 530 Maintenance And Service Manual

Reverse this procedure to install the RTC battery. Be sure the RTC battery is installed with the "+" sign
facing up.

Fan assembly

Description
Fan assembly
Before removing the fan assembly, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Memory/WLAN module compartment cover (see
b.
Optical drive (see
c.
Switch cover (see
d.
Keyboard (see
e.
Display assembly (see
f.
Base enclosure (see
g.
Remove the fan assembly:
Disconnect the fan cable (1) from the system board.
1.
Remove the Phillips PM2.0×9.0 screw (2) that secures the fan assembly to the top cover.
2.
Battery on page 32).
Hard drive on page 33)
Optical drive on page
Switch cover on page
Keyboard on page 43)
Display assembly on page
Base enclosure on page
Memory module on page
39)
41)
47)
52)
Component replacement procedures
Spare part number
438528-001
35)
55