Machine Specific Information; Integrating Video Drivers; General Process - Compaq Armada 110 Deployment Manual

Compaq Guide to PC Deployment
The installation share is now ready. To perform installation, complete the following steps:
1. Boot the target system from a bootable MS-DOS diskette containing network drivers configured for
the NIC in the system.
2. Log on to the network (as required) and map a drive to the network share where the Windows 95
installation files reside.
3. Partition and format the hard drive (if necessary). If you want to use the FAT32 file system (OSR2 or
later only), you should enable large hard drive support in FDISK and create the desired partitioning
size.
4. Copy files from the installation share to the local hard drive.
5. Execute the Windows 95 SETUP.EXE program and specify the MSBATCH.INF file as a command
line parameter (i.e. SETUP.EXE /is /iw MSBATCH.INF).

Machine Specific Information

Compaq recommends obtaining and installing the following Microsoft updates to Windows 95.
For general information, refer to the Microsoft documentation at
http://support.microsoft.com/support/kb/articles/q161/0/20.asp
locating, downloading, and installing Microsoft updates, refer to
http://support.microsoft.com/support/kb/articles/Q119/5/91.asp
LPT.VXD – Retail (OSR0) only – information and instructions can be found at
http://support.microsoft.com/support/kb/articles/q157/9/49.asp
ESDI506.PDR and VOLTRACK.VXD – information can be found at
http://support.microsoft.com/support/kb/articles/q171/3/53.asp
VMM.VXD and VMM32.VXD – information can be found at
http://support.microsoft.com/support/kb/articles/q179/8/97.asp

Integrating Video Drivers

General Process

1. Download each required SoftPAQ to its own directory (under the N:\WIN95 directory) named for the
contents (ex: N:\WIN95\ATI\ for the ATI Technologies video drivers) and execute the SoftPAQ. This
will lay out the files in a directory structure specified by the SoftPAQ.
2. If there are DISKx subdirectories move the contents down one level. For Example ATI\DISK1 would
move to ATI\.
3. Edit the [SourceDisksFiles] section in the driver's installation INF (named in the Errata) to add the
subdirectory name to all of the files listed
PRT/007A/0699
NOTE: These steps may be automated using batch files.
. For more detailed instructions on
.
.
.
.
5
Preliminary