Table of Contents
Advertisement
2. Release the SETUP key.
3. Press and hold the device key on the rubber keypad for
approximately 5 seconds (TV or AUDIO/AUX) for volume
control until the LED indicator light blinks and the Main
Setup Screen is shown.
4. The default volume control is now set for the mode you
have chosen.
VCR Punch-through
The RCU900RF punches through the six transport keys (REVERSE,
PLAY, FORWARD, RECORD, STOP, and PAUSE) to VCR or
DVD Mode, whichever was used most recently. Punch-through
to VCR/DVD transport keys on the rubber keypad is only
allowed for TV, VCR, DVD, and Cable-coded Modes.
AUX, SAT and CD/Audio are dedicated to their
programmed modes.
Record Key
In the VCR and AUDIO/CD Modes (including Punch-through),
the RECORD key on the rubber keypad must be pressed twice
before the command is sent. This is also true if a VCR device is
programmed under any other mode. The exceptions are for
DVD and SAT codes, where the RECORD key transmits the
command after only a single RECORD keypress.
Additional Features
Keypress Beep Feature
Your RCU900RF beeps whenever a key is pressed to acknowledge
the keypress. You can turn this feature on or off. The default
setting is On.
To turn the Keypress Beep on or off, follow these steps:
1. Press and hold the SETUP key on the rubber keypad until
the LED indicator light remains on and the touchscreen
shows the Main Setup Screen. This process takes
approximately 2-3 seconds.
2. Release the SETUP key.
3. Press and hold the MUTE key on the rubber keypad for
approximately 5 seconds until the LED blinks and the Main
Setup Screen is displayed.
4. The Keypress Beep feature is now turned on or off,
depending on the previous state it was in.
LCD Touchscreen Display Time
You can choose the length of time the touchscreen remains on
after the last keypress. The power-on default is 30 seconds from
the last keypress. Setting the LCD Touchscreen Display Time also
changes the length of time the Backlight stays on, if activated.
To change the LCD Touchscreen Display Time, follow these steps:
1. Press and hold the SETUP key on the rubber keypad until
the LED indicator light remains on and the touchscreen
shows the Main Setup Screen. This process takes
approximately 2-3 seconds.
23
Advertisement
Table of Contents
