Table of Contents
Advertisement
RCU310_US_IB_REVB
4/10/03
Program for DVD or VCR—
Direct Entry Method
In order for the 3 component universal remote to control your
DVD or VCR, you must program it with the code that matches
your component. The VCR•DVD key can be programmed
to operate either a DVD or a VCR player. These instructions
explain the preferred method of programming the remote—
the Direct Entry method.
1. Manually turn on the
VCR or DVD player.
2. Locate the enclosed VCR or
DVD Code List. Find your brand
in the VCR Codes or DVD Codes
section, respectively.
CODE
INDICATOR
SEARCH
LIGHT
Note:
of the Code Search methods to program
this remote control (See Code Search
on page 8).
VCR•
(BLINK)
DVD
3. Press and hold the CODE SEARCH
key until the indicator light illuminates.
Then release the CODE SEARCH key.
4. Press and release the VCR•DVD key.
1
2
3
The indicator light blinks and then
4
5
6
remains lit.
7
8
9
5. Use the number keys on the remote to
enter the first code listed for your brand.
0
After you enter a valid three-digit
code, the indicator light turns off.
Note:
the LED will flash rapidly for 2
(OFF)
seconds. Start over at step 3.
ON•OFF
6. Aim the remote at the component
(VCR or DVD player). Press the
ON•OFF key. If your VCR or DVD
player turns off, you have found the
correct code.
VCR OR DVD CODE
7. Enter the code in the box provided
on this page for future reference.
8. If your VCR or DVD player doesn't
turn off, repeat steps 3-6 above,
entering the next code for your brand.
If none of the codes work or your
brand is not listed, use one of the Code
Search methods to program this remote
(See Code Search on page 8).
For a description of each key on
the remote control, refer to the Key
Descriptions section on page 3-4.
6
16:43
Page 6
If your brand isn't listed, use one
If you enter an invalid code,
Hide quick links:
Advertisement
Table of Contents
