Choosing Multiboot Preferences; Setting A New Boot Order In Computer Setup; Dynamically Choosing A Boot Device Using The F9 Prompt; Setting A Multiboot Express Prompt - HP 4410t Administrator's Reference Manual
Mobile thin client
Hide thumbs
Also See for 4410t:
- Printing manual (18 pages) ,
- Maintenance and service manual (125 pages) ,
- Manual (8 pages)
Table of Contents
Advertisement
Choosing Multiboot preferences
You can use MultiBoot in the following ways:
●
To set a new boot order that the computer uses each time it is turned on, by changing the boot
order in Computer Setup.
●
To dynamically choose the boot device by pressing
is displayed in the lower-left corner of the screen when the computer starts up.
●
To use MultiBoot Express to set variable boot orders. This feature prompts you for a boot device
each time the computer is turned on or restarted.
Setting a new boot order in Computer Setup
To set a boot device order that the computer uses each time it is turned on or restarted, follow these
steps:
1.
Open Computer Setup by turning on or restarting the computer, and then pressing
"F10 = ROM Based Setup" message is displayed in the lower-left corner of the screen.
2.
Use the arrow keys to select System Configuration > Boot Options, and then press enter.
3.
Use the arrow keys to select Enable in the MultiBoot field.
NOTE:
4.
Use the arrow keys to select the order that you prefer in the Boot Order fields.
5.
To save your preferences and exit Computer Setup, use the arrow keys to select File > Save
changes and exit. Then follow the instructions on the screen.
Your preferences go into effect when the computer restarts.
Dynamically choosing a boot device using the F9 prompt
To dynamically choose a boot device for the current start up sequence, follow these steps:
1.
Open the Select Boot Device menu by turning on or restarting the computer, and then pressing
f9
while the "F9 = Boot device menu" message is displayed in the lower-left corner of the screen.
2.
Use the arrow keys to select a boot device, and then press enter.
Your preferences go into effect immediately.
Setting a MultiBoot Express prompt
To set the computer to display the MultiBoot startup location menu each time the computer is started
or restarted, follow these steps:
1.
Open Computer Setup by turning on or restarting the computer, and then pressing
"F10 = ROM Based Setup" message is displayed in the lower-left corner of the screen.
2.
Use the arrow keys to select System Configuration > Boot Options, and then press enter.
82
Chapter 15 Multiboot
MultiBoot is enabled at the factory.
f9
while the "F9 = Boot device menu" message
f10
while the
f10
while the
Advertisement
Table of Contents
