Top Panel Modes; Input Mode; Input Source - HHB Portadrive PDR2000 Operation Manual

TOP PANEL MODES

INPUT MODE

Pressing INPUTS on the top panel shows this screen:
To enter a name, move the cursor to the appropriate NAME field, press the ENTER key and enter a
name of your choosing as described previously.
The input parameters are as follows:
PAIRING Adjacent inputs (e.g. 1+2, 3+4, 5+6) can be 'paired' so that either fader associated
with those channels can be used to adjust their levels proportionally. Primarily, this is
useful when using stereo signals. However, you may well find other uses for it. If there
is an offset between the two channels' levels, this offset is retained as either channel
is adjusted.
SOURCE You may select the input source for each channel in this page. The options are:
INPUT 1:
INPUT 2:
INPUT 3:
INPUT 4:
INPUT 5:
INPUT 6:
MIC ATT Microphone attenuation can be set on each channel to 0 (no attenuation), -15, -30dB.
Of course, mic attenuation cannot be applied to digital inputs and when an input
source is digital, the function is not shown.
Similarly, if any channels are LINE inputs, mic attenuation cannot be applied.
MIC HPF This page allows you to apply a high pass filter to microphone inputs to filter out any
unwanted low frequency elements. Each channel's filter can be set to OFF (no filter),
75Hz or 150Hz.
The HPF cannot be applied to digital or line input sources and should any channels be
set up in this way, the function is not shown.
42
MIC, MIC48, LINE, AES1, SDIFL, OFF
MIC, MIC48, LINE, AES2, SDIFR, OFF
MIC, MIC48, LINE, AES3, OFF
MIC, MIC48, LINE, AES4, OFF
MIC, MIC48, LINE, AES5, OFF
MIC, MIC48, LINE, AES6, OFF
Version 1.01