Table of Contents
Advertisement
1. Check if the setpoint match the value in the operating parameter
2. Open the front door and check if connectors are well connected for each oven
3. Refer to drawing ''Motherboard PCB'' of the drawing section 8.0 to identify the fuse used for each oven.
Oven temperature
deviation
4. Check the status of the LED used for the defective oven. Refer to the drawing ''Motherboard PCB'' of the
5. Contact LDetek support
1. Check the raw signals referring to the operating parameter sheet (refer to start up procedure section 4.3)
Detector off alarm
2. Contact LDetek support
1. Check if there are flow alarms and resolve them
2. Check if there are oven temperature deviation alarms and resolve them
3. Check if there are detector off alarm and resolve them
Lost peaks
4. Check the raw signals of the detectors by referring to the operating parameter. The raw signal must be at a
5. Contact LDetek support
1. Check if the green LED is ON on the right bottom corner
Display off or unit
2. If the green LED is OFF, then check if power is well supply to the unit. Make sure it is the right power
doesn't start
Check if the fuses are not blown by removing them and measuring the continuity of it
drawing section 8.0. The green LED turns on when the oven is heating. Check if the LED is ON or OFF or
blinking. If the setpoint is 50Celsius and the reading value is 10Celsius, then the LED should be ON all the
time
(support@ldetek.com)
(support@ldetek.com)
value +/- 20% of the factory values. To see the raw signals, refer to the start-up procedure section 4.3
(support@ldetek.com)
voltage by referring to the model number of the instrument or the red indicator on the power inlet module
on the back panel
with the results obtained in the previous steps
with the results obtained in the previous steps
with the results obtained in the previous steps
72
Advertisement
Table of Contents
