Table of Contents
Advertisement
Pct Alert:
The percentage of deviation allowed before the flow deviation
alert
Low Limit:
The lowest value to be considered as a normal condition. If we have
reading lower than that, the system will stop trying to control it.
Because there is probably something wrong, a broken sensor for
instance.
Hi Limit:
The highest value to be considered as a normal condition. If we
have reading higher than that, the system will stop trying to control
it. Because there is probably something wrong, a broken cable for
instance.
Lookup Table:
This is the table to convert the sensor reading into units
Time Table:
It contains the setpoint for the flow.
The "(at start)" is the setpoint to reach when no analysis is running.
In other words, before an analysis start. You can add more setpoint
at different time in an analysis.
Flow LookUp:
This is where you can select a LookUp table from the list. This is
normally used when different balance gases are used as sample gas.
MULTIDETEK 2 User's manual
46
Advertisement
Table of Contents
