Work Stations - MIRKA PBS 10NV Operating Instructions Manual

®
Mirka PBS 10NV 10 x 330 mm
Vibration level * 1.88 m/s
Vibration emission 0.68 m/s
uncertainty K *
The noise test is carried out in accordance with EN ISO 15744:2008 Hand-held non-electric power tools Noise
measurement code Engineering method (grade 2).
The vibration test is carried out in accordance with EN ISO 20643:2008 Mechanical Vibration Hand-held and Hand-guided
Machinery Principles for Evaluation of Vibration Emission.
Specifications subject to change without prior notice. Model range may vary between markets.
* The values stated in the table are derived from laboratory testing in conformity with stated codes and standards and
are not sufficient for risk evaluation. Values measured in a particular work place may be higher than the declared
values. The actual exposure values and amount of risk or harm experienced by an individual are unique to each
situation and depend upon the surrounding environment, the way the individual operates the machinery, the par-
ticular material being worked, work station design and the user's exposure time and physical condition. Mirka Ltd
accepts no responsibility for the consequences of using declared values instead of actual exposure values for any
individual risk assessment.
Further occupational health and safety information can be obtained from the following websites:
https://osha.europa.eu/en (Europe) or http://www.osha.gov (USA)
Proper use of tool
This tool is designed for sanding all types of materials i.e. metals, wood, stone, plastics, etc. using abrasive designed for
this purpose. Do not use this tool for any other purpose than specified, without consulting your Mirka dealer.

Work stations

The tool is intended to be operated as a hand-held tool. It is always recommended that the tool should be used when
standing on a solid floor. It can be in any position but before any such use, the operator must be in a secure position,
having a firm grip and footing and be aware that the sander can develop a torque reaction. See the section Operating
instructions .
Operating instructions
When unpacking the tool, make sure it is intact, complete and has not been damaged in transport. Never use a damaged
tool.
Use a clean lubricated air supply that will give a measured air pressure at the tool of 6.2 bar (90 psig) when the tool is
running with the lever fully pressed. It is recommended to use an approved 10 mm (3/8") x 8 m (25 ft) maximum length
air hose. The tool should be connected to the air supply as shown in Figure 1.
Do not connect the tool to the compressed air system without incorporating an easy to reach and operate air shutoff
valve. It is strongly recommended that an air filter, regulator and lubricator (FRL) are used as shown in Figure 1 as this
will supply clean, lubricated air at the correct pressure to the tool. Details of such equipment can be obtained from your
supplier. If such equipment is not used the tool should be manually lubricated.
To manually lubricate the tool, disconnect the air hose and put 2 to 3 drops of supplied oil or Wurth art. no. 08930505
into the air connection on the tool. Reconnect the tool to the air supply and run the tool slowly for a few seconds to allow
air to circulate the oil. If the tool is used frequently, lubricate it on a daily basis.
It is recommended that the air pressure at the tool is 6.2 bar (90 psig) while the tool is running. The tool can run at lower
pressures but never higher than 6.2 bar (90 psig).
2
2
13NV 12.7 x 457 mm
1.04 m/s 2
2
0.59 m/s
en (original)
Mirka® PBS 10NV & 13NV
47