Page 2
Index. Page. Index Tool parts produced after 10/2013, from serial no: 201310 17823 Parts list after 10/2013, from serial no: 201310 17823 Tool parts produced before 09/2013, until serial no: 201308 17822 Parts list before 09/2013, until serial no: 201308 17822 Instructions.
Page 3
Exploded view for Polisher PS1437 Updated 11.12.2013 For tools produced after 10/2013, from serial no: 201310 17823...
Page 4
Parts list Spare parts for PS1437 produced from 10/2013, from serial no: 201310 17823 Pos. Code Description 8991302111 Field 8991303111 Switch 8991304111 Strain relief 8991305111 Cable comp 8991306111 Locking Button 8991307111 Spring 8991308111 Locking Pin 8991309111 Screw 8991310111 Gear Housing 8991311111 Needle Bearing 8991312111...
Page 5
Exploded view for Polisher PS1437 Updated 11.12.2013 For tools produced before 09/2013, until serial no: 201308 17822...
Page 6
Parts list Spare parts for PS1437 produced before 09/2013, until serial no: 201308 17822 Pos. Code Description 8991301111 Armature 8991302111 Field 8991303111 Switch 8991304111 Strain relief 8991305111 Cable comp 8991306111 Locking Button 8991307111 Spring 8991308111 Locking Pin 8991309111 Screw 8991310111 Gear Housing 8991311111 Needle Bearing...
Page 7
Open screws (14) and lift off the drive shaft assembly (55) Open screws (42) and remove the bail grip (41) Open screws (9) and pull out the gear housing (10) Tool: V7675 PE14-3A Mirka code: 8995910611 Pinion in the gear housing. Pinion tool to unscrew the pinion.
Page 8
Clamp the armature in a vice, protect the armature with a strip of soft material. Attach the pinion tool as shown in the picture, and unscrew the pinion counter clockwise. With the pinion (53) unscrewed pull the armature (50) out of the bearing. The bearing (18) is locked in the gear housing (10) with a retaining ring (19).
Page 9
Reassemble the parts in gear housing (10) and fill with new grease (24 g). Open screws (36) to access the electrical parts. Insert the armature halfway in to the motor housing (33), lift the brushes with a screwdriver to get the collector in correct position. Collector in correct position, carbon brush in contact with the collector.
Page 10
Replacing the armature (1) in tool up to serial no: 201308 17822 Open the gear housing as decribed on page 7. Clamp the armature in a vice, protect the armature with a strip of soft material. Use two screwdrivers to keep the sleeve (16) against the housing, and turn the housing counter clockwise to unscrew the sleeve.
Page 11
Identification by serial number and type Type: PS 1437 Mirka type: 8991300111 Serial number: 11/2013 17963 Type: PS 1437 Mirka type: 8991300111 Serial number: 07/2012 16700...