Display Assembly - HP ProBook 445 G9 Maintenance And Service Manual

Table 6-10 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the power connector cable:
1. Move the antenna cables that route over the right screw (1).
2. Remove the three Phillips M2.5 × 4.0 screws (2) that secure the right display hinge to the computer, and
then rotate the hinge off the power connector (3).
3. Disconnect the cable from the system board (4).
4. Remove the power connector cable from the computer (5).
Reverse this procedure to install the power connector cable.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
4. Remove the power connector cable (see
Preparation for disassembly on page
Bottom cover on page 38).
Preparation for disassembly on page
Bottom cover on page 38).
Power connector cable on page
38).
Battery on page 48).
38).
Battery on page 48).
58).
Component replacement procedures
Spare part number
M21725-001
59