Indicator Message (Error Message) - Dukane 6542W User Manual

Indicator Message (Error message)

POWER STATUS
Off Orange
Status varies Off
Status varies
Off
Blue (Blink* ) Off
4
Red (Blink* ) Off
4
Red Red (Blink* )
4
Red Red
Red (Blink* ) Green
4
*1 Repetition to light on for 1.5 seconds / off for 1.5 seconds
*2 Repetition to light on for 1.5 seconds / off for 7.5 seconds
*3 Repetition to light on for 2.5 seconds / off for 0.5 seconds
*4 Repetition to light on for 0.5 seconds / off for 0.5 seconds
• When the thermal protector is activated:
When inside temperature of the projector becomes too high or low, the POWER indicator start to red blink in a
short cycle. After this happened, the thermal protector will activate and the projector may be turned off.
In this case, please take the below measures:
- Pull out the power plug from the wall inlet.
- Place the projector in cool place if it has been placed in high ambient temperature.
- Clean the exhaust vent if dust has accumulated on.
- Leave the projector for about one hour until inside temperature gets lower.
LAMP
A button has been pressed while the
KEY LOCK is activated.
Off
ID numbers for the projector and the
remote control do not match.
Lamp replacement grace period.
Orange (Blink* )
4
Lamp replacement time exceeded.
Red (Blink* )
4
Preparing to relight lamp after lighting
has failed.
Green (Blink* )
4
Temperature problem
Off
Power problem
Off
FAN problem
Off
Lamp does not light.
Red
Projector status
91
10. Appendix
Procedure
The projector's keys are locked. The
setting must be canceled to operate the
→
projector. ( page 39)
→
Check the control IDs (
The lamp has reached the end of its
service life and is now in the replace-
ment grace period (Between lamp life
and 110% of lamp life). Replace the
lamp to new one as soon as possible.
→
( page 85)
The lamp has exceeded its replacement
time (More than 110% of lamp life). Re-
place the lamp immediately.
Wait a while.
Ambient temperature is out of the opera-
tion temperature. Check if any obstruction
stays near the exhaust vent.
Please contact your dealer or service
personnel.
Please contact your dealer or service
personnel.
Wait at least 1 minute, then turn on the
power back on. If the lamp still does
not light, contact your dealer or service
personnel.
page 52)