Connecting Alarms
A1,A2,A3,A4 (Alarm Input 1,2,3,4)
You can use external devices to signal the dome camera to react on events. Mechanical or
electrical switches can be wired to the A1,A2,A3,A4 (Alarm Input 1,2,3,4) and G (Ground)
connectors.
G (Ground)
NOTICE: All the connectors marked G or GND are common.
i
Connect the ground side of the alarm input and/or alarm output to the G (Ground)
connector.
AO (Alarm Output)
The dome camera can activate external devices such as buzzers or lights. Connect the
device to the AO (Alarm Output) and G (Ground) connectors.
Connecting the Power
Connect power of 12VDC or 24VAC for the dome camera.
Connect the positive (+) pole to the '+' position and the negative (-) pole to the '-' position.
CAUTION:
Network Connection & IP Assignment
The eneo Site Manager (downloadable from www.eneo-security.com) is used to locate all
eneo network cameras in a local network. Download and install the software from
www.eneo-security.com. Start the program. You will receive a list of available cameras in
the local network.
10
• Be careful not to reverse the polarity when you connect
the power cable.
• You can also use a router featuring PoE (Power over Ether-
net) to supply power to the camera.