Table of Contents
Advertisement
2. Click Hardware and Sound.
3. Click Sound.
4. Click the Recording tab in the Sound window.
5. Select Microphone, and click the Properties button.
6. Click the Levels tab, and move the Microphone Boost slider upwards.
7. Click OK.
Note: For more information about controlling volume, see the Windows online help.
• Problem: A volume or balance slider cannot be moved.
Solution: The slider might be grayed out. This means that its position is fixed by the hardware and
cannot be changed.
• Problem: The volume sliders do not stay in place when some audio programs are used.
Solution: It is normal for the sliders to change position when certain sound programs are used. The
programs are aware of the settings in the Volume Mixer window and are allowed to change the settings
themselves. An example is the Windows Media Player. Usually the program has sliders available to
control the sound from within the program.
• Problem: The balance slider cannot completely mute one channel.
Solution: The control is designed to compensate for minor differences in balance and does not
completely mute either channel.
• Problem: The sound cannot be turned off completely even if you set the Master volume control at
minimum.
Solution: You still can hear some sound even though you have set the Volume Mixer control at minimum.
To turn off the sound completely, press the speaker mute button.
• Problem: When you connect a headphone to your computer while playing sound, a speaker does not
produce sound.
Solution: Once the headphone is attached, the streaming is automatically redirected to it. If you want to
listen to sound from the speakers again, be sure to set those speakers as the default device. For more
information, see the help information system for Realtek HD Audio.
Fingerprint reader problems
• Problem: The surface of the reader is dirty, stained, or wet.
Solution: Gently clean the surface of the reader with a dry, soft, lint-free cloth.
• Problem: The reader often fails to enroll or authenticate your fingerprint.
Solution: If the surface of the reader is dirty, stained, or wet, gently clean the surface of the reader
with a dry, soft, lint-free cloth.
For tips on how to maintain the fingerprint reader, see "Using the fingerprint reader" on page 53.
Battery and power problems
This topic contains instructions on troubleshooting batteries and power problems.
Battery problems
• Problem: The batteries cannot be fully charged in the standard charge time when the computer is
powered off.
Solution: The batteries might be over-discharged. Do the following:
1. Turn off the computer.
.
Chapter 10
Troubleshooting computer problems
133
Advertisement
Table of Contents
