Troubleshooting - Sub-Zero IT36CIRH Use & Care Manual

Integrated refrigeration
Hide thumbs Also See for IT36CIRH:
Table of Contents

Advertisement

Available languages

Available languages

T R O U B LE S HO O T I NG

Troubleshooting

U N IT O P E R AT I O N
No lights or cooling.
Verify power is on.
Verify electrical power to unit and home circuit breaker
is on.
No lights in refrigerator or freezer.
Door | drawer may have been left ajar which has disabled
lights to eliminate excess heat. If lights are out, close
door | drawer for one hour. If lights are still out, contact
Sub-Zero factory certified service.
LED interior lighting must be replaced by Sub-Zero
factory certified service.
Frost, condensation or ice build up inside unit.
Verify condenser is clean.
Verify door | drawer is closing properly.
Verify door | drawer has not been left ajar.
Verify door | drawer gasket does not have rips or tears. If
it does, contact Sub-Zero factory certified service.
If icing is heavy, turn unit off and use a hair dryer to melt
ice. Hair dryer should be set on low and kept moving
at all times. Once ice has melted, wipe up water with a
cloth or paper towel.
High temperatures, unit runs excessively or unit giving off
too much heat.
Verify condenser is clean.
Verify door | drawer is closing properly.
Verify door | drawer has not been left ajar.
Increased ambient temperatures may cause compres-
sors to run longer.
If temperature display shows 38° and 0°, but is not
cooling, unit may be in showroom mode. Contact
Sub-Zero Customer Care at 800-222-7820.
No water from dispenser.
Wait one hour, then try dispenser again. Contact
Sub-Zero Customer Care at 800-222-7820 if unresolved.
|
subzero.com
17

Advertisement

Table of Contents
loading

Table of Contents