Table of Contents
Advertisement
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 57.
2. Remove the front bezel. See "Front bezel" on page 58.
3. Press the release tab
Figure 89. Pivoting the drive bay assembly upward
4. Locate the secondary hard disk drive. See "Computer components" on page 5.
5. Disconnect the signal cable and the power cable from the hard disk drive.
6. Remove the cable clip on the bottom of the primary hard-disk-drive bay as shown.
Figure 90. Removing the cable clip
7. Align the four holes in the secondary hard-disk-drive cage with the corresponding four tabs on the
bottom of the bay as shown. Then, position the cage onto the bottom of the primary hard-disk-drive bay
so that the tabs on the bay pass through the holes in the cage.
102
P320 User Guide
1
as shown and pivot the drive bay assembly upward.
Advertisement
Table of Contents
