TechVision NS16P2P8 Manual page 90

NVR User Manual
Alarm Management
Check "Draw Area" and then click around the area where you want to set as the alarm area in
the image (the alarm area should be a closed area). Uncheck the "Draw Area" if you finish the
drawing. Click the "Clear" to delete the alarm area.
⑤ Click "Apply" to save the settings.
⑥ Click "Processing Mode" to go to the alarm handling configuration interface of intrusion
detection.
Intrusion Detection Alarm Handling Configuration:
① Click StartSettingsAlarmIntelligence AlarmIntrusion to go to the following
interface.
② Enable or disable "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video"
and "E-mail". The alarm handling setting of intrusion detection alarm is similar to that of the
84