TechVision NS16P2P8 Manual page 86

NVR User Manual
Alarm Management
by the users.
③ Select the alarm area. A maximum of 4 alarm areas can be set.
④ Draw the alarm area of the object detection. Refer to the interface as shown above. Check
"Draw Area" and then click around the area where you want to set as the alarm area in the
image (the alarm area should be a closed area). Uncheck the "Draw Area" if you finish the
drawing. Click the "Clear" to delete the alarm area.
⑤ Click "Apply" to save the settings.
⑥ Click "Processing Mode" to go to the alarm handling configuration interface of object
detection.
Object Detection Alarm Handling Configuration:
① Click StartSettingsAlarmIntelligence AlarmObject Detection to go to the
following interface.
80