Camera Management
Add Manually
Enter the IP address or domain name (click
name input window, input the domain name of the IPC in the window and then click "OK"),
port, username and password of the camera and then select the protocol. Click "Test" to test the
effectiveness of the input information and then click the "Add" button (you can input one
camera's information or above such as IP address, username and password before clicking the
"Add" button). Click
username and password of each camera.
Note: Some models may not support this function.
Click StartSettingsSystemBasicGeneral Settings to check "Enable Add IPC by
Zero Operation". If the NVR has unoccupied channels, it can add IPC without any operation
by restarting.
Add Recorder
Quickly Add:Select the searched NVR/DVR and the click "Add" to add NVR in the
same local network.
Manually Add:Click "Manual Add" and then enter the IP address or domain name,
port, username and password of the NVR/DVR. Check the added remote channel
number and click "Test" to test the effectiveness of the input information. Then click
"OK" to return to the previous interface.
in the IP address column to pop up the domain
to delete the camera. Click "Default Password" to set the default
28
NVR User Manual